Exam-Killer H35-260 Exam Questions | Real H35-260 Practice Dumps
Verified H35-260 Exam Dumps Q&As - Provide H35-260 with Correct Answers
NEW QUESTION 180
When using the LCAS function, which of the following overhead bytes are used to transmit control information?
- A. K2
- B. K4
- C. M1
- D. H4
Answer: B,D
NEW QUESTION 181
According to the formula of ODUk rate2391C 239K) STMHM to car: ODUI to car 239/235- STMN frame rate.
- A. False
- B. True
Answer: A
NEW QUESTION 182
Which of the following alarms will be reported by the peer end when it is detected that the error code exceeds the limit in the B2 byte?
- A. MS-REI
- B. MS-BBE
- C. RS-BBE
- D. MS-AIS
Answer: A
NEW QUESTION 183
What options are included in the role of the control word in PWE3?
- A. Carrying Layer 2 frame header control information
- B. Carry MPLS labels
- C. Carry the sequence number forwarded by the packet
- D. Fill the message to prevent the message from being too short
Answer: A,C,D
NEW QUESTION 184
When the device reports the PW_APS_DEGRADED alarm, what is the problem with the LTE service carried by the station?
- A. The working protection channel is invalid
- B. None of the working protection channels fail
- C. One of the working protection channels fails
- D. Business interruption
Answer: C
NEW QUESTION 185
Which of the following descriptions is correct?
- A. OptiX PTN supports encapsulating E1 frames of different connections into one PW
- B. SAToP encapsulation type processes the CES service by encapsulating the 32 time slots in the E1 frame as a whole and then transparently transmitting it to the opposite end
- C. One STM-1 channel contains 64 VC12 time slots
- D. SAToP supports time division suppression
Answer: B
NEW QUESTION 186
Which of the following descriptions about single-site commissioning is wrong?
- A. After the hardware inspection of the single station is completed, make sure that all power switches are in the off position
- B. In the case of power failure, you can contact the board without wearing an anti-static wrist or anti-static gloves
- C. If the input voltage of the equipment is not within the required range, a rectification suggestion should be put forward, and power-on is strictly prohibited
- D. It is strictly forbidden to plug and unplug the power plug and PIU single board while electrified
Answer: B
NEW QUESTION 187
When creating an electrical layer path, what options (Client, ODUK, ODUflex) may cause the route calculation to fail
- A. Routing resources are unavailable
- B. The optical power attenuation on the service layer path OCH is too large
- C. Services cannot be created between ports
- D. Unable to satisfy routing constraints
Answer: A,C,D
NEW QUESTION 188
On the U2000 network management, you can make an inner ring and an outer ring on the PTNE1 port to facilitate testing
- A. False
- B. True
Answer: A
NEW QUESTION 189
When configuring SxCS board for OSN3500. Which of the following is the access capacity of a fully configured subrack?
- A. 35G
- B. 155G
- C. 80G
- D. 58.75G
Answer: B
NEW QUESTION 190
In the PIN LTE bearer solution, if the link between the core L3 PTN node and the SGW is faulty, what are the triggering detection mechanisms and protection mechanisms?
- A. BFD, VPN FRR
- B. MPLS OAM, SVPN FRR
- C. BFD, IP/VPN FRR
- D. MPLS OAM, IP/VPN FRR
Answer: C
NEW QUESTION 191
Which of the following statements about multiplexed partial range error indication (MS-REI) is true B2 byte represents the transmission channel.
- A. MS-REI is transmitted from source to receiver
- B. Indicates the number of bit errors detected by the receiver after receiving the MS signal.
- C. MS-REI is sent from the receiver to the source.
- D. M1 byte folder indicates the transmission channel
Answer: B
NEW QUESTION 192
The 1588V2 clock protocol can realize clock and time synchronization, and the working modes are OC, BC, TC.
- A. True
- B. False
Answer: A
NEW QUESTION 193
Which of the following technologies is used in the dynamic BGP MPLS L3VPN to distinguish the same IP address prefix in different VPNs in the BGP protocol?
- A. VRF
- B. Export RD
- C. RD
- D. Import RD
Answer: C
NEW QUESTION 194
The U2000 license file is stored in the following directory /u2000/server path. If the license file is invalid, the U2000 will not work normally.
- A. False
- B. True
Answer: A
NEW QUESTION 195
In PTN, LSP is created statically. Which items are correct in the following description about LSP creation?
- A. Multiple labels can be assigned to the same A FEC
- B. The value of the outgoing label of the previous node and the incoming label of the next node are equal
- C. Tunnel is being created, PHP is not enabled
- D. The label values on different nodes of the LSP cannot be the same
Answer: A,B,C
NEW QUESTION 196
In the PTN network, what are the parameters for measuring QOS?
- A. Bit Error Rate
- B. Jitter
- C. Bandwidth
- D. Delay
- E. Packet Loss Rate
Answer: B,C,D,E
NEW QUESTION 197
The 802.1Q tag header contains a two-byte TPID. Which of the following is its standard value?
- A. 0
- B. 1
- C. 2
- D. 88A8
Answer: A
NEW QUESTION 198
......
Get Top-Rated Huawei H35-260 Exam Dumps Now: https://www.exam-killer.com/H35-260-valid-questions.html
