Instantly download HPE6-A46 updated real questions

HP HPE6-A46 Exam Overview:

HP HPE6-A46 Exam Syllabus Topics:

HP Delta-Aruba Certified Switching Professional Sample Questions:

Question 1

Refer to the exhibit.

An AOS-Switch connects to an unmanaged switch in a meeting room. The exhibit shows security settings for this port. Users report that they sometimes lose connectivity and then get it back.
Which best practice should network administrators follow to avoid this issue?

A. Port security and loop protection should not be enabled on the same port.
B. Eavesdrop prevention should be disabled when port security is in limited-continuous mode.
C. Loop protection should operate in VLAN mode, rather than port mode, when port security is enabled.
D. The loop protection and port security actions should be set to match.

Question 2

Refer to the exhibit.

An administrator created a backplane stack with the plug-and-play method and did not alter the default backplane stacking settings. Later, two backplane stacking links failed as shown in the exhibit. The network administrator then restored the failed links.
When the stack is reformed, which switches become commander and standby?

A. Member 1 becomes commander, and Member 4 becomes standby
B. Member 4 remains commander, and Member 1 becomes standby
C. Member 1 becomes commander, and Member 2 becomes standby
D. Member 4 remains commander, and Member 5 remains standby

Question 3

A network administrator needs to find the source of a performance issue. The administrator has seen that interfaces sometimes start to drop many packets, but the issue is intermittent, and the administrator is not sure exactly when it happens. The administrator wants to be alerted when interfaces start to drop packets. The switches already have an SNMP trap server configured on them.
What else should an administrator do on these switches?

A. Set the trap server to inform mode
B. Enable debugging to the session
C. Set up RMON alarms on dropped packet statistics
D. Enable link change SNMP traps on the switch

Question 4

Refer to the exhibit.

Every switch shown in the exhibit is an AOS-Switch that runs PIM-SM. A network administrator wants to load-balance the RP role, so Switch-3 and Switch-4 both act as RPs for some of the multicast groups. How should the administrator configure the RPs?

A. Specify the candidate RP command on Switch-3. Also specify the candidate RP command on Switch-4.
B. Specify 10.3.3.3 as a static RP address on Switch-1. Specify 10.4.4.4 as a static RP address on Switch-2.
C. Specify 10.3.3.3 as a static RP address on half of the AOS-Switches and 10.4.4.4 as a static RP address on the other half.
D. Specify Switch-3 and Switch-4 IP addresses as candidate RP addresses on Switch-1. Specify the same candidate addresses on Switch-2.

Question 5

A network administrator needs to create a backplane stack with four AOS-Switches. The administrator wants to choose which switch becomes the commander. Which procedure meets those needs?

A. Configure backplane switches settings on each switch while disconnected. Make sure the desired commander has priority value 1. Then, connect the switches.
B. Configure backplane switching settings on each switch while disconnected. Make sure the desired commander has member ID 1. Then, connect the switches.
C. Boot up the desired commander first and make sure stacking is enabled on it. Then, connect the stacking links and boot the other switches.
D. Boot all of the switches at the same time and then connect the backplane stacking links. Then, access the desired commander, and make sure it has member ID 1.

Solutions: